

You want to close the crack as much as possible and hold it in place for the glue to dry. For this example, you’ll slot one clamp in at the third fret and the other in at the fourth. You want one side of the clamp on top of the caul and the other on the fretboard.

Place 2 or more Irwin quick-grip clamps on the neck depending on the length of the crack. Clamp the caul down to hold the join in place.Place the guitar neck support caul, like this one, on top of wax paper.This will prevent the glue from bonding to the caul and clamps when it seeps out after clamping. Place the wax paper over the glued crack.You don’t want to glue your cloth to your workbench. Place the cloth aside with the glue side facing upward. Wipe off the excess glue with the damp cloth.Make sure it flows into the gap as much as possible. Apply the glue along the length of the crack.Pretend to execute the following steps and see how quickly you can do them: To give you an idea, you will likely need to execute steps 2 to 5 below within about 5 seconds to be safe. Practicing is vital because the Starbond CA Super Glue dries lightning fast. Do a proper ‘dress rehearsal’ with a closed glue bottle and all the other elements. Starbond EM-02 Premium Instant CA Super Glue with a micro-tip pipetteīefore opening your glue, practice the steps involved until you are sure of your methodology.Irwin Quick-Grip One-Handed Bar Clamps (2 or more clamps).Guitar Neck Support Caul (like this one).Wax paper (Larger than the area of the crack).To apply the Starbond CA super glue (or similar) to the opening, you will need the following: Apply the CA Super Glue Supplies You’ll Need Now you are ready for the gluing phase of the process.
#GIBSON LES PAUL NECK JOINT CRACK CRACKED#
The best way to do this is to blow on the cracked section when open before gluing. You should also ensure that the crack is as dust-free as possible. But try to open the crack a little in a way that at least leaves you with one hand free. Take care not to place so much pressure on the area that you increase the size of the crack. If there’s any way you can clamp the neck to hold it in that position, that will help. Gently and gradually apply a small amount of pressure to open the crack up a little. You also need to have the fretboard exposed for clamping. This pressure will make the repair job difficult for you. The tension your strings place on the neck of the guitar will place unnecessary pressure on the crack. Prepare the Crackīefore starting, you must remove the strings from your guitar. The following is a step-by-step guide to see you through the repair process hassle-free.

Let’s say that the opening runs behind the third and fourth frets.
